Pulled all but one of the pins on the Kubota loader today, cleaned them and reinstalled them. What a dry rusty mess. Very impressive handwritten maintenance records but whoever was doing it before me was better with a pencil than a grease gun. Learned through trial and error, mostly error, that some pins were easiest to deal with when the hydraulics relaxed, some needed a light load to r&r.
started a job
22 Replies, 711 Views![[-]](https://www.alpharomeo15.org/images/roundo/collapse_collapsed.png)
| Messages In This Thread |
|
started a job - by tommag - 04-30-2026, 09:09 AM
RE: started a job - by Towtruck - 04-30-2026, 03:48 PM
RE: started a job - by Rampy - 04-30-2026, 09:00 PM
RE: started a job - by specops56 - 05-01-2026, 09:49 AM
RE: started a job - by tommag - 05-01-2026, 12:40 AM
RE: started a job - by Pepper - 05-04-2026, 12:29 PM
RE: started a job - by Towtruck - 05-04-2026, 02:13 PM
RE: started a job - by Rampy - 05-06-2026, 11:57 PM
RE: started a job - by specops56 - 05-07-2026, 08:57 AM
RE: started a job - by wes556 - 05-13-2026, 01:59 PM
RE: started a job - by tommag - 05-05-2026, 10:36 PM
RE: started a job - by hkriflenut_aka_sasquatch - 05-15-2026, 01:40 PM
RE: started a job - by olfart - 05-15-2026, 04:36 PM
RE: started a job - by hkriflenut_aka_sasquatch - 05-15-2026, 06:01 PM
RE: started a job - by Towtruck - 05-15-2026, 05:14 PM
RE: started a job - by olfart - 05-15-2026, 06:25 PM
RE: started a job - by hkriflenut_aka_sasquatch - 05-16-2026, 12:58 AM
RE: started a job - by Towtruck - 05-15-2026, 09:13 PM
RE: started a job - by tommag - 05-15-2026, 09:55 PM
RE: started a job - by Rampy - 05-16-2026, 05:54 PM
RE: started a job - by hkriflenut_aka_sasquatch - 05-24-2026, 10:47 PM
RE: started a job - by olfart - 05-24-2026, 11:06 PM
RE: started a job - by tommag - Yesterday, 11:10 PM
|
Users browsing this thread: 1 Guest(s)