Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is there no way.....
(This post was last modified: 08-14-2024, 05:23 AM by RocketFoot.)
I have been less active with guns as well.  Plus a lot of the action has moved to social media and is just strangling traditional forums!  Seem like only the big ones like Arfcom, BladeForums, etc...are doing well.  Us little guys can't make a go of it anymore.  It doesn't help that Google and other search giants are systematically waging war against gun and knife sites!  We can't get the page rankings to even be found when searching!
[Image: large.RF_BULLET_BANNERcopy3-min.png.b253...93824c.png]
[-] The following 1 user Likes RocketFoot's post:
  
REPLY



Messages In This Thread
Is there no way..... - by specops56 - 08-12-2024, 09:53 AM
RE: Is there no way..... - by tommag - 08-12-2024, 11:01 AM
RE: Is there no way..... - by specops56 - 08-12-2024, 11:11 AM
RE: Is there no way..... - by tommag - 08-12-2024, 11:47 AM
RE: Is there no way..... - by specops56 - 08-12-2024, 04:23 PM
RE: Is there no way..... - by RocketFoot - 08-13-2024, 05:15 AM
RE: Is there no way..... - by speedy - 08-13-2024, 08:06 AM
RE: Is there no way..... - by srjdsmith - 08-13-2024, 11:25 AM
RE: Is there no way..... - by Rampy - 08-13-2024, 03:46 PM
RE: Is there no way..... - by srjdsmith - 08-13-2024, 09:57 PM
RE: Is there no way..... - by Rampy - 08-14-2024, 02:09 PM
RE: Is there no way..... - by tommag - 08-13-2024, 04:25 PM
RE: Is there no way..... - by RocketFoot - 08-14-2024, 05:20 AM
RE: Is there no way..... - by tommag - 08-14-2024, 05:30 AM
RE: Is there no way..... - by srjdsmith - 08-14-2024, 08:03 AM
RE: Is there no way..... - by specops56 - 08-14-2024, 08:47 AM
RE: Is there no way..... - by Rampy - 08-14-2024, 02:15 PM
RE: Is there no way..... - by speedy - 08-14-2024, 11:13 AM
RE: Is there no way..... - by specops56 - 08-14-2024, 01:38 PM
RE: Is there no way..... - by Rampy - 08-14-2024, 02:11 PM
RE: Is there no way..... - by olfart - 08-14-2024, 10:13 AM
RE: Is there no way..... - by specops56 - 08-14-2024, 11:05 AM
RE: Is there no way..... - by olfart - 08-14-2024, 03:51 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)
Benchmade Knives